One cool thing about overland camping, is the many other activities that can be done in conjunction with it. Hiking, swimming, fishing, kayaking…the list is endless. And while there isn’t anything much better than camping next to a stream or lake, there isn’t anything much worse than watching fish swim back and forth and not having your fishing pole with you.

When packing for an overland trip, bringing a rod and reel, isn’t as high on the list of importance as other things. Poles are long, fragile, and hard to store easily, especially if they aren’t two piece rods. When pre packing for an upcoming trip, I was trying to figure out how to fit a couple rods into my Jeep Unlimited, without breaking them or having them be in the way. My favorite rods don’t break down, so I had to opt for my back up rods which are two pieces and easier to transport. I decided to try and make a rod holder, than instead of being inside the vehicle, was outside. A way they would be safe and I could have them at easy reach without lots of unpacking.

I decided to start with some 3″ PVC pipe. I bought a solid end cap for one end and a threaded/screw type cap for the other end. I also picked up some PVC cement. I was only able to buy the pipe long enough in a 10′ stick, so there is enough left over to make a couple of these depending how long you want to make yours. Total cost was about $30.

I measured my longest rod (broken down to two pieces) to get an idea how long I wanted it to go. I can also store marshmallow cookers and my fire poker in it as well, so keep in mind for extra space, if you would like to use it for other things.

I had some aluminum clamps I got off Ebay for fairly cheap, sitting around, which worked perfectly for this. Drill a couple holes in the PVC to bolt them to it. I used some 3/8″ bolts with washers. IMPORTANT!!! Remember to bolt these on before cementing the ends (like I did) which makes it very hard to tighten them up.

I scuffed the outer surface, then coated the entire thing in spray on bedliner. We will see how well it holds before having to recoat it.